[uClibc]remote gdb makefile? (building gdb to use with gdbserver)
andersen at codepoet.org
Mon Mar 10 22:14:38 UTC 2003
On Mon Mar 10, 2003 at 01:58:51PM -0800, David Wuertele wrote:
> I'm trying to compile gdbserver and a gdb to go along with it for
> mipsel. gdbserver compiles fine, but the gdb that runs on my dev
> system must be able to read the symbols in the mipsel-uclibc
> executable. I think I can build this by just changing the --host=
> parameter to configure in the gdb.mk file, and having it install that
> in the toolchain directory instead of the target root directory. Does
> that sound right? Has anyone done this work already?
> As a separate question, I noticed the following output during the
> configure step of building gdbserver:
> configure: warning: Could not find libthread_db.
> configure: warning: Disabling thread support in gdbserver.
> I looked for libthread* in the toolchain but didn't find it. Is this
> something that I can enable?
You need to enable PTHREADS_DEBUG_SUPPORT in uClibc'c .config
Erik B. Andersen http://codepoet-consulting.com/
--This message was written using 73% post-consumer electrons--
More information about the uClibc