[uClibc]Re: Fwd: OpenSSH problems

Erik Andersen andersen at codepoet.org
Thu Oct 31 09:40:39 UTC 2002


On Thu Oct 31, 2002 at 10:11:44AM +0300, Valera wrote:
> Hello!
> 
> I have compiled together with library uClibc the following
> components: busybox, tinylogin, firewall (iptables utilities), VLAN 802.1Q
> utility, Dillon's Cron, ntpclient. All this works well.

A good start!

> But I can't compile OpenSSH (openssh_3.4p1) with uClibc.
> For the information(inquiry): for construction uClibc-based system I
> use Linux Slackware 8.0 and uClibc-0.9.15 wrapper.
> I have executed all recommendations given by Erik Andersen in the
> letter (see below) from October, 21 2002:
> 
> > There are several ways to approach solving this problem.  Step
> > one is to make sure you have built and installed zlib into the
> > directory where you are putting your shared libraries (in the
> > above case, into ~/staging_dir).  This is the easy part.
> 
> > There are several possible ways to approach step two.  The
> > easiest way to fix things up (assuming you built uClibc with
> > SHARED_LIB_LOADER_PATH=/lib and are both building on and building
> > for x86 systems) is to create a ld-uClibc.so.0 symlink
> > in the /lib directory of your build system.
> 
> But these measures did not give desirable result.
> In that letter Eric Andersen also has written:

Where is your uClibc development environment installed?
What does 'ls -l /lib/ld-uClibc.so.0' show?  

 -Erik

--
Erik B. Andersen             http://codepoet-consulting.com/
--This message was written using 73% post-consumer electrons--



More information about the uClibc mailing list