[uClibc][uClinux-dev] Can't Run User Program after Installing uClibc?

[Erik Andersen]

On Tue Aug 14, 2001 at 07:29:58AM -0400, Larry Gray wrote:
> Hello,
> 	I just installed the latest uClibc snapshot, I can compile fine, but when I 
> try to run the program on a uCsimm I get the following: P:not found. The 
> program compiled and ran fine with uC-libc. I used the Config.m68k.coff file, 
> and just change the DEVEL_PREFIX to (TARGET_ARCH)-pic-coff. I did try setting 
> DOPIC = true, but uClibc would not compile. What am I doing wrong?
> 
> 	Should I also upgrade to the m68k-elf tools? If so will they work with my 
> existing environment, or would I have to start from scratch? 
 
Using uClibc with m68k-coff is a fairly new thing, and while it
should work, in theory, doing so has not been extensively tested
and I do expect some problems to show up.  So my recommendation
is that, unless you want to get your fingers a bit dirty, you
may want to reconsider using uClibc with m68k-coff.

In general, I feel much more confident about uClibc with the 
m68k-elf tools, but if you do want to proceed with m68k-coff,
I'll be happy to try and help.  The better your bug reports
are, the more I'll be able to help,

 -Erik

--
Erik B. Andersen   email:  andersen at lineo.com
--This message was written using 73% post-consumer electrons--